THERMAL SCIENCE

International Scientific Journal

Authors of this Paper

External Links

Jianping Cheng

,

Hongsen Xu

,

Zhiguo Tang

,

Pei Zhou

STUDY ON SINGLE-PHASE AND TWO-PHASE FLOW AND HEAT TRANSFER CHARACTERISTICS OF HFE-7100 IN MANIFOLD MICROCHANNEL HEAT SINK WITH CORRUGATED BOTTOM

ABSTRACT
To solve the problem of high heat flux heat dissipation in microelectronic devices, a manifold micro-channel heat sink with corrugated bottom (CB-MMC) is pro-posed on the basis of the manifold microchannel heat sink (MMC). The flow and heat transfer characteristics of HFE-7100 in MMC and CB-MMC are investigated numerically. The results show that CB-MMC reduces the pressure loss and enhances the heat transfer performance in single-phase flow. The orthogonal test method is used to obtain structural design solutions with optimal thermal performance. It is observed that the temperature reduction is always at the expense of the increase of the pressure drop. In addition, the optimization parameters combination obtained through comprehensive evaluation of temperature and pressure drop through weight matrix – optimized solution 19 (wavelength A = 800 μm, am-plitude B = 40 μm, channel depth C = 180 μm, outlet width D = 300 μm, channel width E = 25 μm). Its Tave has decreased by 6.89°C, ΔP decreased by 10.27 kPa. Moreover, the subcooled boiling flow and heat transfer performance in MMC and CB-MMC are comparatively studied. The results demonstrate that the dynamic behavior of vapor bubbles causes large pressure fluctuations, which further leads to small temperature fluctuations, and thus reduces the stability of the flow and boiling heat transfer. Compared with MMC, CB-MMC exhibits more stable two-phase flow and better boiling heat transfer.
KEYWORDS
Manifold microchannel, Corrugated bottom, orthogonal test, flow boiling, enhanced heat transfer
PAPER SUBMITTED: 2023-07-07
PAPER REVISED: 2023-09-06
PAPER ACCEPTED: 2023-09-11
PUBLISHED ONLINE: 2023-10-08
DOI REFERENCE: https://doi.org/10.2298/TSCI230707213C
CITATION EXPORT: view in browser or download as text file
THERMAL SCIENCE YEAR 2024, VOLUME 28, ISSUE Issue 2, PAGES [1819 - 1836]
REFERENCES
  1. Ebadian, M. A., Lin, C. X., A Review of High-Heat-Flux Heat Removal Technologies, Journal of Heat Transfer, 133 (2011), 11, pp. 1-11
  2. Tuckerman, D. B., Pease, R. F. W., High-Performance Heat Sinking for VLSI, IEEE Electron Device Letters, 2 (1981), 5, pp. 126-129
  3. Ye, M., et al., Experimental Study on Heat Transfer Performance and Flow Visualization in Microchannels with Micropillars, Thermal Science, 26 (2022), 5B, pp. 4169-4178
  4. Bashir, S., et al., Simulations of Convective Heat Transfer in Rectangular Microchannel Using Thermal Lattice Boltzmann Method, Thermal Science, 26 (2022), Special Issue 1, pp. 219-228
  5. Vinoth, R., Senthil, K., Numerical Study of Inlet Cross-Section Effect on Oblique Finned Microchannel Heat Sink, Thermal Science, 22 (2018), 6B, pp. 2747-2757
  6. Gunnasegaran, P., et al., The Effect of Geometrical Parameters on Heat Transfer Characteristics of Mi-crochannels Heat Sink with Different Shapes, International Communications in Heat and Mass Transfer, 37 (2010), 8, pp. 1078-1086
  7. Kose, H. A., et al., Parametric Study and Optimization of Microchannel Heat Sinks with Various Shapes, Applied Thermal Engineering, 211 (2022), 118368
  8. Peng, X. F., Peterson, G. P., Convective Heat Transfer and Flow Friction for Water Flow in Microchannel Structures, International Journal of Heat and Mass Transfer, 39 (1996), 12, pp. 2599-2608
  9. Anwar, M., et al., Numerical Study for Heat Transfer Enhancement Using Cuo Water Nanofluids Through Mini-Channel Heat Sinks for Microprocessor Cooling, Thermal Science, 24 (2020), 5A, pp. 2965-2976
  10. Sahar, A. M., et al., Effect of Hydraulic Diameter and Aspect Ratio on Single Phase Flow and Heat Trans-fer in a Rectangular Microchannel, Applied Thermal Engineering, 115 (2017), Mar., pp. 793-814
  11. Yuan, B., et al., Heat Transfer Enhancement on Micro-Pin-Finned Surfaces Under High-Frequency Re-ciprocating Flow, Applied Thermal Engineering, 175 (2020), 115378
  12. Esmaili, Q., et al., Experimental Analysis of Heat Transfer in Ribbed Microchannel, International Journal of Thermal Sciences, 130 (2018), Aug., pp. 140-147
  13. Feng, S., et al., Thermal Management of 3D Chip with Non-Uniform Hotspots by Integrated Gradient Distribution Annular-Cavity Micro-Pin Fins, Applied Thermal Engineering, 182 (2021), 116132
  14. Wan, Z., et al., Flow Characteristics and Heat Transfer Performance of Half-Corrugated Microchannels, Applied Thermal Engineering, 123 (2017),Aug., pp. 1140-1151
  15. Kermani, E., et al., Experimental Investigation of Heat Transfer Performance of a Manifold Microchannel Heat Sink for Cooling of Concentrated Solar Cells, Proceedings, 59th Electronic Components and Tech-nology Conference, San Diego, Cal., USA, 2009, pp. 453-459
  16. Harpole, G. M., Eninger, J. E., Microchannel Heat-Exchanger Optimization, Proceedings, 7th Annual IEEE Semiconductor Thermal Measurement and Manag. Sym., Scottsdale, Ariz., USA, 1991, pp. 59-63
  17. Chen, C., et al., Investigation of Flow and Heat Transfer Performance of the Manifold Microchannel with Different Manifold Arrangements, Case Studies in Thermal Engineering, 34 (2022), 102073
  18. Tang, W., et al., Improvement of Flow Distribution and Heat Transfer Performance of a Self-Similarity Heat Sink with a Modification to Its Structure, Applied Thermal Eng., 121 (2017), July, pp. 163-171
  19. Ju, X., et al., Numerical Investigation of a Novel Manifold Micro-Pin-Fin Heat Sink Combining Chess-board Nozzle-Jet Concept for Ultra-High Heat Flux Removal, International Journal of Heat and Mass Transfer, 126 (2018), Part B, pp. 1206-1218
  20. Pourfattah, F., et al., On the Thermal Characteristics of a Manifold Microchannel Heat Sink Subjected to Nanofluid Using Two-Phase Flow Simulation, International Journal of Heat and Mass Transfer, 143 (2019), 118518
  21. Pan, Y. H., et al., Study on the Effect of Varying Channel Aspect Ratio on Heat Transfer Performance of Manifold Microchannel Heat Sink, International Journal of Heat and Mass Transfer, 163 (2020), 120461
  22. Huang, X., et al., Heat Transfer Enhancement on a Microchannel Heat Sink with Impinging Jets and Dim-ples, International Journal of Heat and Mass Transfer, 112 (2017), Sept., pp. 113-124
  23. Adio, S. A., et al., Thermal and Entropy Analysis of a Manifold Microchannel Heat Sink Operating on CuO-Water Nanofluid, J. of the Brazilian Society of Mech. Sciences and Eng., 43 (2021), 2, pp. 1-15
  24. Pan, Y. H., et al., Study on the Flow and Heat Transfer Characteristics of Pin-Fin Manifold Microchannel Heat Sink, International Journal of Heat and Mass Transfer, 183 (2022), 122052
  25. Pan, Y. H., et al., Numerical Study on Heat Transfer Characteristics of a Pin-Fin Staggered Manifold Microchannel Heat Sink, Applied Thermal Engineering, 219 (2023), 119436
  26. Chen, C., et al., Improvement of Flow and Heat Transfer Performance of Manifold Microchannel with Porous Fins, Applied Thermal Engineering, 206 (2022), 118129
  27. Karayiannis, T. G., Mahmoud, M. M., Flow Boiling in Microchannels: Fundamentals and Applications, Applied Thermal Engineering, 115 (2017), Mar., pp. 1372-1397
  28. Drummond, K. P., et al., A Hierarchical Manifold Microchannel Heat Sink Array for High-Heat-Flux Two-Phase Cooling of Electronics, Int. J. of Heat and Mass Transfer, 117 (2018), Feb., pp. 319-330
  29. Xie, W., et al., Numerical Investigation of Flow Boiling in Manifold Microchannel-Based Heat Exchang-ers, International Journal of Heat and Mass Transfer, 163 (2020), 120493
  30. Mukherjee, A., Kandlikar, S. G., Numerical Simulation of Growth of a Vapor Bubble During Flow Boiling of Water in a Microchannel, Microfluidics and Nanofluidics, 1 (2005), 2, pp. 137-145
  31. Lin, Y., et al., Single-Phase and Two-Phase Flow and Heat Transfer in Microchannel Heat Sink with Various Manifold Arrangements, International Journal of Heat and Mass Transfer, 171 (2021), 121118
  32. Luo, Y., et al., A Numerical Study of Subcooled Flow Boiling in a Manifold Microchannel Heat Sink with Varying Inlet-to-Outlet Width Ratio, Int. J. of Heat and Mass Transfer, 139 (2019), Aug., pp. 554-563
  33. Akbarzadeh, M., et al., Influences of Corrugation Profiles on Entropy Generation, Heat Transfer, Pressure Drop, and Performance in a Wavy Channel, Applied Thermal Engineering, 116 (2017), Apr., pp. 278-291
  34. Lee, W. H., A Pressure Iteration Scheme for Two-Phase Flow Modeling, in: Multiphase Transport Fun-damentals ,Reactor Safety, Applications (Ed. T.N. Veziroglu), Hemisphere Pub., Washington, 1980
  35. Yang, Z., et al., Numerical and Experimental Investigation of Two Phase Flow During Boiling in a Coiled Tube, International Journal of Heat and Mass Transfer, 51 (2008), 5-6, pp. 1003-1016
  36. Chen, B., et al., Flooded Two-Phase Flow Dynamics and Heat Transfer With Engineered Wettability on Microstructured Surfaces, Journal of Heat Transfer, 137 (2015), 9, 091021
  37. Peng, M., et al., Numerical Study on Flow and Heat Transfer in a Multi-Jet Microchannel Heat Sink, International Journal of Heat and Mass Transfer, 157 (2020), 119982
  38. Zuo, W., et al., Orthogonal Experimental Design and Fuzzy Grey Relational Analysis for Emitter Effi-ciency of the Micro-Cylindrical Combustor with a Step, App. Ther. Eng., 103 (2016), June, pp. 945-951
  39. E, J. Q., et al., Orthogonal Experimental Design of Liquid-Cooling Structure on the Cooling Effect of a Liquid-Cooled Battery Thermal Management System, App. Ther. Eng., 132 (2018), Mar., pp. 508-520
  40. Luo, Y., et al., Analysis of Thermal Performance and Pressure Loss of Subcooled Flow Boiling in Mani-fold Microchannel Heat Sink, International Journal of Heat and Mass Transfer, 162 (2020), 120362
  41. Yuan, Y., et al., Numerical Investigation of Flow Boiling Heat Transfer in Manifold Microchannels, Ap-plied Thermal Engineering, 217 (2022), 119268
PDF VERSION [DOWNLOAD]
Study on single-phase and two-phase flow and heat transfer characteristics of HFE-7100 in manifold microchannel heat sink with corrugated bottom

© 2024 Society of Thermal Engineers of Serbia. Published by the Vinča Institute of Nuclear Sciences, National Institute of the Republic of Serbia, Belgrade, Serbia. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International licence