International Scientific Journal

Thermal Science - Online First

online first only

Investigation of gasification reactions and H2/CO ratio analysis for rice husk air gasification simulation

The syngas generated during gasification process is used for industrial process heat, power generation and chemical feedstock production. Gas composition, H2/CO and CO/CO2 ratios are the deciding factors for producer gas end-use. In the present work, rice husk air gasification simulation is carried out by non-stoichiometric equilibrium model using Gibbs free energy minimization by FactSage 6.3 software. Influence of gasification reactions and effect of temperature, equivalence ratio on gas composition was studied. The analysis was carried out to study the effect of operating conditions on producer gas heating value and gasification efficiency at various H2/CO ratios. Increase in temperature improves H2 and CO formation in water gas reaction and reduction of H2 formation was observed in water gas shift reaction due to endothermic behavior change. For all the values of the equivalence ratio (f),an increase in temperature reduces the H2/CO and enhances the CO/CO2 ratio due to higher CO formation. For a particular f value, maximum gas heating value and gasification efficiency were obtained at low H2/CO ratio.
PAPER REVISED: 2022-04-26
PAPER ACCEPTED: 2022-04-28
  1. ***, Ministry of New and Renewable Energy, Government of India, › bio-energy › current-status
  2. Niu, Y., et al., Experimental study on steam gasification of pine particles for hydrogen-rich gas, Journal of Energy Institute, 90 (2016),pp. 715-724
  3. Zainal, Z.A., et al., Prediction of performance of a downdraft gasifier using equilibrium modelling for different biomass materials, Energy Conversion and Management, 42 (2001), pp. 1499- 1515
  4. Ardebili, Z.R., et al., Influence of the effective parameters on H2:CO ratio of syngas at low temperature gasification, Chemical Engineering Transactions, 37 (2014), pp. 253-258
  5. Tristantini, D., et al., The effect of synthesis gas composition on the Fischer-Tropsch synthesis over Co/γ-Al2O3 and Co-Re/ γ-Al2O3 catalysts, Fuel Processing Technology, 88 (2007), pp. 643-649
  6. Cao, Y., et al., Synthesis gas production with an adjustable H2/CO ratio through the coal gasification process: effects of coal ranks and methane addition, Energy fuels, 22 (2008), pp. 1720-1730
  7. Buragohain, B., et al., Thermodynamic optimization of biomass gasification for decentralized power generation and Fischer-Tropsch synthesis, Energy, 35 (2010), pp. 2557-2579
  8. Karmakar, M.K., et al., Investigation of fuel gas generation in a pilot scale fluidized bed autothermal gasifier using rice husk, Fuel, 111 (2013), pp. 584-591
  9. Li, X., et al., Equilibrium modeling of gasification: a free energy minimization approach and its application to a circulating fluidized bed coal gasifier, Fuel, 80 (2001), pp. 195-207
  10. Altafini, C.R., et al., Prediction of the working parameters of a wood waste gasifier through an equilibrium model, Energy Conversion and Management, 44 (2003) pp. 2763-2777
  11. Yoshida, H., et al., Two stage equilibrium model for a coal gasifier to predict the accurate carbon conversion in hydrogen production, Fuel, 87 (2008) pp. 2186-2193
  12. Lan, C., et al., Thermodynamic and kinetic behaviors of coal gasification, Thermochimica Acta, 666 (2018) 174-180
  13. Syed Shabbar, Isam Janajreh, Thermodynamic equilibrium analysis of coal gasification using Gibbs energy minimization method, Energy conversion and management, 65 (2013), pp.755-763
  14. Cheng, G., et al., Gasification of biomass micron fuel with oxygen-enriched air: Thermogravimetric analysis and gasification in a cyclone furnace, Energy, 43 (2012), pp. 329-333
  15. Proll, T., Hofbauer, H., H2 rich syngas by selective CO2 removal from biomass gasification in a dual fluidized bed system-process modelling approach, Fuel Processing Technology, 89 (2008), pp. 1207-1217
  16. Ngo, S.I., et al., Performance evaluation for dual circulating fluidized-bed steam gasifier of biomass using quasi-equilibrium three-stage gasification model, Applied Energy, 88 (2011), pp. 5208-5220
  17. Dillibabu, V., et al., Energy, exergy and sustainability analysis of rice husk air gasification process, Thermal Science, 23 (2019), pp.549-560
  18. Dillibabu, V.,, Air and oxygen gasification simulation analysis of sawdust, Thermal Science, 23 (2019), pp.1043-1053
  19. Mohamed Zakriya, G., Ramakrishnan, G., Insulation and mechanical properties of jute and hollow conjugated polyester reinforced nonwoven composite, Energy and Buildings, 158 (2018), pp.1544-1552
  20. Mothilal, T., Pitchandi, K., Influence of inlet velocity of air and solid particle feed rate on holdup mass and heat transfer characteristics in cyclone heat exchanger, Journal of Mechanical Science and Technology, 29 (2015), pp.4509-4518
  21. Subramanian, P., et al., Fluidized bed gasification of select granular biomaterials, Bioresource Technology, 102 (2011), pp. 1914-1920
  22. Azzone, E., et al., Development of an equilibrium model for the simulation of thermo chemical gasification and application to agricultural residues, Renewable Energy, 46 (2012), pp. 248-254
  23. Gambarotta, A., et al., A non-stoichiometric equilibrium model for the simulation of the biomass gasification process, Applied Energy, 227 (2018), pp. 119-127
  24. Gai, C., Dong, Y., Experimental study on non-woody biomass gasification in a downdraft gasifier, International Journal of Hydrogen Energy, 37 (2012), pp. 4935-4944
  25. Loha, C., et al., Performance of fluidized bed steam gasification of biomass-modeling and experiment, Energy Conversion and Management, 52 (2011), pp. 1583-1588
  26. Melgar, A., et al., Thermochemical equilibrium modelling of a gasifying process, Energy Conversion and Management, 48 (2007), pp. 59-67
  27. Parvez, A.M., et al., Energy, exergy and environmental analyses of conventional, steam and CO2-enhanced rice straw gasification, Energy, 94 (2016), pp. 579-588
  28. Rosen, M.A., et al., Role of exergy in increasing efficiency and sustainability and reducing environmental impact, Energy Policy, 36 (2008), pp. 128-137
  29. Wang, L.Q., Chen, Z.S., Gas generation by co-gasification of biomass and coal in an autothermal fluidized bed gasifier, Applied Thermal Engineering, 59 (2013), pp. 278-282
  30. Bridgwater, A.V., Renewable fuels and chemicals by thermal processing of biomass, Chemical Engineering Journal, 91 (2003), pp. 87-102
  31. Broer, K.M., et al., Steam/oxygen gasification system for the production of clean syngas from switchgrass, Fuel, 140 (2015), pp. 282-292
  32. Moghadam, R.A., et al., Investigation on syngas production via biomass conversion through the integration of pyrolysis and air-steam gasification processes, Energy Conversion and Management, 87 (2014), pp. 670-675