THERMAL SCIENCE
International Scientific Journal
FLOW BOILING HEAT TRANSFER COEFFICIENT OF R-134A/R-290/R-600A MIXTURE IN A SMOOTH HORIZONTAL TUBE
ABSTRACT
An investigation on in-tube flow boiling heat transfer of R-134a/R-290/R-600a (91%/4.068%/4.932% by mass) refrigerant mixture has been carried out in a varied heat flux condition using a tube-in-tube counter-flow test section. The boiling heat transfer coefficients at temperatures between -5 and 5°C for mass flow rates varying from 3 to 5 g/s were experimentally arrived. Acetone is used as hot fluid, which flows in the outer tube of diameter 28.57 mm, while the test fluid flows in the inner tube of diameter 9.52 mm. By regulating the acetone flow rate and its entry temperature, different heat flux conditions between 2 and 8 kW/m2 were maintained. The pressure of the refrigerant was maintained at 3.5, 4, and 5 bar. Flow pattern maps constructed for the considered operating conditions indicated that the flow was predominantly stratified and stratified wavy. The heat transfer coefficient was found to vary between 500 and 2200 W/m2K. The effect of nucleate boiling prevailing even at high vapor quality in a low mass and heat flux application is high-lighted. The comparison of experimental results with the familiar correlations showed that the correlations over predict the heat transfer coefficients of this mixture.
KEYWORDS
PAPER SUBMITTED: 2007-12-21
PAPER REVISED: 2008-02-28
PAPER ACCEPTED: 2008-03-12
THERMAL SCIENCE YEAR
2008, VOLUME
12, ISSUE
Issue 3, PAGES [33 - 44]
- ***, United Nations Environment Programme, Montreal Protocol on Substances that Deplete the Ozone Layer. Final Act, 1989
- Devotta, S., Gopichand, S., Comparative Assessment of HFC134a and Some Refrigerants as Alternatives to CFC12, Int. J. Refrigeration, 15 (1992), 2, pp. 112-118
- Devotta, S., Parande, M. G., Patwardhan, V. R., Performance and Heat Transfer Characteristics of HFC-134a and CFC-12 in a Water Chiller, Applied Thermal Engg., 18 (1998), 7, pp. 569-578
- Jung, D., Kim, C. B., Lim, B. H., Lee, H.W., Testing of a Hydrocarbon Mixture in Domestic Refrigerators, ASHRAE Trans. 1996, pp. 1077-1184
- Fatouh, M., El Kafafy, M., Assessment of Propane/Commercial Butane Mixtures as Possible Alternatives to R134a in Domestic Refrigerators, Energy Conversion and Management, 47 (2006), 15-16, pp. 2644-2658
- Sekhar, S. J., Kumar, K. S., Lal, D. M., Ozone Friendly HFC134a/HC Mixture Compatible with Mineral Oil in Refrigeration System Improves Energy Efficiency of a Walk in Cooler, Energy Conversion and Management, 45 (2004), 7-8, pp. 1175-1186
- Sekhar, S. J., Premnath, R. P., Lal, D. M., On the Performance of HFC134a/HC600a/HC290 Mixture in a CFC12 Compressor with Mineral Oil as Lubricant, EcoLibrium - Journal of Australian Institute of Refrigeration, Air Conditioning and Heating, 2 (2003), 4, pp. 24-29
- Chen, J. C., Correlation for Boiling Heat Transfer to Saturated Fluids in Convective Flow, Industrial and Engineering Chemistry Process Design and Development, 5 (1966), 3, pp. 322-329
- Jung, D. S., et al., A Study of Flow Boiling Heat Transfer with Refrigerant Mixtures, Int. J. of Heat and Mass Transfer, 32 (1989), 9, pp. 1751-1764
- Jung, D. S., et al., Horizontal Flow Boiling Heat Transfer Experiments with a Mixture of R22/R114, Int. J. Heat Mass Transfer, 32 (1989), 9, pp. 131-145
- Shin, J. Y., Kim, M. S., Ro, S. T., Experimental Study on Forced Convective Boiling Heat Transfer of Pure Refrigerants and Refrigerant Mixtures in a Horizontal Tube, Int. J. Refrigeration, 20 (1997), 4, pp. 267-275
- Wattelet, J. P., et al., Evaporative Characteristics of R12, R134a and a Mixture at Low Mass Fluxes, ASHRAE Trans. Symposia, 2 (1994), 1, pp. 603-615
- Jabardo, J. M. S., Filho, E. P. B., Convective Boiling of Halocarbon Refrigerants Flowing in a Horizontal Copper Tube an Experimental Study, Thermal and Fluid Science, 23 (2000), 3, pp. 93-104
- Aprea, C., Rossi, F., Greco, A., Experimental Evaluation of R22 and R407C Evaporative Heat Transfer Coefficient in a Vapour Compression Plant, Int. J. Refrigeration, 23 (2000), 5, pp. 366-377
- Ross, H., et al., Horizontal Flow Boiling of Pure and Mixed Refrigerants, Int. J. Heat Mass Transfer, 30 (1987), 5, pp. 979-992
- Kattan, N., Thome, J. R., Favrat, D., Flow Boiling in Horizontal Tubes: Part 1 - Development of a Diabatic Two-Phase Flow Pattern Map, J. of Heat Transfer, 120 (1998), 1, pp. 140-147
- Kattan, N., Thome, J. R., Favrat, D., Flow Boiling in Horizontal Tubes: Part 3 - Development of a New Heat Transfer Model Based on Flow Pattern, J. of Heat Transfer, 120 (1998), 1, pp. 156-165
- Gungor, K. E., Winterton, R. H. S., A General Correlation for Flow Boiling in Tubes and Annuli, Int. J. Heat Mass Transfer, 29 (1986), 3, pp. 351-358
- Gungor, K. E., Winterton, R. H. S., Simplified General Correlation for Saturated Flow Boiling and Comparisons of Correlations with Data, Chem. Eng Res. Des., 65 (1987), March, pp. 148-156
- Shah, M. M., Chart Correlation for Saturated Boiling Heat Transfer: Equations and Further Study, ASHRAE Transaction, 88 (1982), 1, pp. 185-196
- Kandlikar, S. G., A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes, J. of Heat Transfer, 112 (1990), 1, pp. 219-228
- Thome, J. R., Update on Advances in Flow Pattern Based Two-Phase Heat Transfer Models, Experimental Thermal and Fluid Science, 29 (2005), 3, pp. 341-349
- Boissieux, X., Heikal, M. R., Johns, R. A., Two-Phase Heat Transfer Coefficient of Three HFC Refrigerants Inside a Horizontal Smooth Tube, Part I: Evaporation, Int. J. of Refrigeration, 23 (2000), 4, pp. 269-283
- ***, REFPROP, NIST Standard Reference Database 23, Version 7.01, 2004
- Moffat, R. J., Describing the Uncertainties in Experimental Results, Experimental Thermal and Fluid Science, 1 (1988), 3, pp. 3-17
- Wojtan, L., Ursenbacher, T., Thome, J. R., Measurement of Dynamic Void Fractions in Stratified Types of Flow, Experimental Thermal and Fluid Science, 29 (2005), 3, pp. 383-392