ABSTRACT
To overcome the problem of rapid depletion of natural energy reserves and consequent pollution caused by them, this work explored the possibility of utilizing sewage sludge biomass to produce biooil using hydrothermal liquefaction pathway. In this study, effect of different reaction parameters such as reaction temperature, residence time, and sludge-to-water ratio on solid biomass conversion and bioyield and its higher heating value were investigated. Although maximum conversion of (99.7%) and highest biooil yield (22.01 wt.%) was achieved at 330°C, however optimum temperature was chosen as 300°C which produced conversion efficiency and yield of biooil very close (98.07% and 21.5 wt.%, respectively) to what was obtained at 330°C as lower temperature is beneficial for overall economy of the process. Similarly, a residence time of 60 minutes and sludge-to-water ratio of 1:6 was screened to be producing optimized yield of biooil. The higher heating valu of different fractions biooil was much improved (30.18 MJ/kg of acetone phase and 38.04 MJ/kg of dichloromethane phase) as compared to that of raw feedstock (12.74 MJ/kg). Carbon balance performed on the products indicated that maximum amount of carbon went to biooil phase (53.4 wt.%). However, a significant portion of carbon was lost (33.9 wt.%) due to the limitation of experiments at lab scale which involves evaporation and drying to reach final products. The Fourier transform infrared spectroscopy spectral analysis of different biooil phases showed that it was mainly made up of alcohols, alkane, ketones, aldehydes and carboxylic acids.
KEYWORDS
PAPER SUBMITTED: 2023-07-28
PAPER REVISED: 2023-10-10
PAPER ACCEPTED: 2023-10-22
PUBLISHED ONLINE: 2023-12-10
THERMAL SCIENCE YEAR
2024, VOLUME
28, ISSUE
Issue 3, PAGES [2683 - 2692]
- Seehar, T. H., et al., Influence of Process Conditions on Hydrothermal Liquefaction of Eucalyptus Biomass for biocrude Production and Investigation of the Inorganics Distribution, Sustainable Energy and Fuels, 5 (2021), 5, pp. 1477-1487.
- Makarigakis, A. K., Jimenez-Cisneros, B.E., UNESCO's Contribution Face Global Water Challenges, Water, 11 (2019), 2, 388
- Siddiqi, M. H., et al., Evolution of Kinetic and Hydrothermal Study of Refused Derived Fuels: Thermo-Gravimetric Analysis, Energy Reports, 17 (2021), Nov., pp. 1757-1764
- Lalli, C. M., Parsons, T. R., Human Impacts on Marine Biota, in Biological Oceanography: An Introduction, 2nd ed., (Eds. C. M. Lalli, T. R. Parsons), Butterworth-Heinemann: Oxford, UK, 1997, pp. 247-265, Chapter 9
- Prajitno, H., et al., Efficient Renewable Fuel Production from Sewage Sludge Using a Supercritical Fluid Route, Fuel, 200 (2017), July, pp. 146-152
- Manarvi, I. A., Ayub, M., Issues and Remedies of Sewage Treatment and Disposal in Islamabad, Pakistan. Chemistry and Materials Research, 3 (2013), 9, mpp. 108-118.
- Javed, T., et al., An Overview of Environmental Pollution Status and Waste Treatment Technology Used in Pakistan, International Atomic Energy Agency (IAEA), 1998, p. 521-530.
- Perea-Moreno, M.-A., et al., Biomass as Renewable Energy: Worldwide Research Trends, Sustainability, 11 (2019), 863
- Fan, Y., et al., Hydrothermal Liquefaction of Sewage Sludge for Biofuel Application: A Review on Fundamentals, Current Challenges and Strategies, Biomass and Bioenergy, 165 (2022), 106570
- Adar, E., et al., Supercritical Water Gasification of Sewage Sludge by Continuous Flow Tubular Reactor: A Pilot Scale Study, Chemical Engineering Journal, 391 (2020), 123499
- Rorat, A., et al., Sanitary and Environmental Aspects of Sewage Sludge Management, in: Industrial and Municipal Sludge, University Lille, Lille, France, 2019, pp. 155-180
- Li, Y. H., et al., Characterization of Oxide Scales Formed on Heating Equipment in Supercritical Water Gasification Process for Producing Hydrogen, International Journal of Hydrogen Energy, 44 (2019), 56, pp. 29508-29515.
- Kruse, A., et al., Hydrothermal Conversion of Biomass to Fuels and Energetic Materials, Current Opinion in Chemical Biology, 17 (2013), 13, pp. 515-521
- Vardon, D. R., et al., Chemical Properties of Biocrude-Oil from the Hydrothermal Liquefaction of Spirulina Algae, Swine Manure, and Digested Anaerobic Sludge, Bioresource Technology, 102 (2011), 17, pp. 8295-8303
- Yang, C., et al., Hydrothermal Liquefaction of an Animal Carcass for Biocrude-oil, Energy and Fuels, 33 (2019), 11, pp. 11302-11309
- Ross, A. B., et al., Hydrothermal Processing of Microalgae Using Alkali and Organic Acids, Fuel, 89 (2010), 9, pp. 2234-2243
- Guo, Y., et al., Hydrothermal liquefaction of Cyanophyta: Evaluation of Potential Biocrude-Oil Production and component Analysis, Algal Research, 11 (2015), Sept., pp. 242-247
- Akhtar, J., Amin, N. A. S., A Review on Process Conditions for Optimum Biooil Yield in Hydrothermal Liquefaction of Biomass, Renewable and Sustainable Energy Reviews, 15 (2011), 3, pp. 1615-1624
- Zeb, H., et al., High-Yield Biooil Production from Macroalgae (Saccharina Japonica) in Supercritical Ethanol and Its Combustion Behavior, Chemical Engineering Journal, 327 (2017), Nov., pp. 79-90
- Suman, S., Gautam, S., Effect of Pyrolysis Time and Temperature on the Characterization of Biochars Derived from Biomass, Energy Sources - Part A: Recovery, Utilization, and Environmental Effects, 39 (2017), 9, pp. 933-940
- Tomczyk, A., et al., Biochar Physicochemical Properties: Pyrolysis Temperature and Feedstock Kind Effects, Reviews in Environmental Science and Bio/Technology, 19 (2020), Feb., pp. 191-215
- Ali, L., et al., Evaluation of Kinetic Behaviour of Refused Derived Fuel Samples by Using Thermogravimetric Analysis, Thermal Science, 27 (2023), 4A, pp. 2739-2749