ABSTRACT
This study compared the fuel consumption and exhaust emissions of a spark-ignition engine using a carburetor fuel system, an injection fuel system, and an ultrasonic fuel system. When using gasoline only, the ultrasonic fuel system showed a 31% decrease in fuel consumption compared to the carburetor system and a 15% decrease compared to the injection system. When adding 10% bioethanol to the gasoline, fuel consumption increased in all three systems, with the ultrasonic system showing the largest increase of 10%. Exhaust emissions were also measured, and the ultrasonic system showed a significant decrease in CO, HC, and NOx compared to the carburetor and injection systems, with the largest decrease in CO emissions. The addition of bioethanol to the fuel resulted in reducing exhaust emission values in all three systems, with the ultrasonic system showing the largest decrease in CO and HC emissions compared to the carburetor and injection systems, but with an increase in NOx emissions compared to the injection system. When comparing three fuel systems, it was observed that injection fuel systems have the highest CO2 values. Although the addition of alcohol to the fuel does not cause a significant change in CO2 emission values for injection and ultrasonic fuel systems, an increase is observed in the carburetor fuel system. Overall, the ultrasonic fuel system showed promising results for reducing fuel consumption and improving exhaust emissions.
KEYWORDS
PAPER SUBMITTED: 2023-03-18
PAPER REVISED: 2023-06-16
PAPER ACCEPTED: 2023-06-24
PUBLISHED ONLINE: 2023-08-05
THERMAL SCIENCE YEAR
2024, VOLUME
28, ISSUE
Issue 2, PAGES [811 - 822]
- Atmanli, A., Effects of a Cetane Improver on Fuel Properties and Engine Characteristics of a Diesel Engine Fueled with the Blends of Diesel, Hazelnut Oil and Higher Carbon Alcohol, Fuel, 172 (2016), May, pp. 209-217
- Banani, R., et al., Waste Frying Oil with High Levels of Free Fatty Acids as One of the Prominent Sources of Biodiesel Production, J. Mater. Environ. Sci, 6 (2015), 4, pp. 1178-1185
- Stojiljković, D., et al., Mixtures of Bioethanol and Gasoline as a Fuel for SI Engines, Thermal science, 13 (2009), 3, pp. 219-228
- Manisalidis, I., et al., Environmental and Health Impacts of Air Pollution: A Review, Frontiers in Public Health, 8 (2020), 14
- Yasar, F., et al., Change in Calculated Carbon Aromaticity Index (CCAI) Depending on Cetane Indexes of Biodiesel Fuels of Different Origin, Proceedings, Global Energy Conference (GEC), 2022, Batman, Turkey, pp. 352-356
- Alves, B. F., et al., Influence of Solvent Solubility Parameter on the Performance of EVA Copolymers as Pour Point Modifiers of Waxy Model-Systems, Fuel, 258 (2019), 116196
- Reitz, R. D. Duraisamy, G., Review of High Efficiency and Clean Reactivity Controlled Compression Ignition (RCCI) Combustion in Internal Combustion Engines, Progress in Energy and Combustion Science, 46 (2015), Feb., pp. 12-71
- Gautam, M., Martin, D. W., Combustion Characteristics of Higher-Alcohol/Gasoline Blends, Proceedings of the Institution of Mechanical Engineers, Part A: J. of Power and Energy, 214 (2000), 5, pp. 497-511
- Munuswamy, D. B., et al., Critical Review on Effects of Alcohols and Nanoadditives on Performance and Emission in Low-Temperature Combustion Engines: Advances and Perspectives, Energy & Fuels, 36 (2022), 14, pp. 7245-7268
- Okcu, M., et al., Effects of Isopropanol-Butanol-Ethanol (IBE) on Combustion Characteristics of a RCCI Engine Fueled by Biodiesel Fuel, Sustainable Energy Technologies and Assessments, 47 (2021), 101443
- Altun, S., et al., Exhaust Emissions from a Spark-Ignition Engine Operating on Iso-Propanol and Unleaded Gasoline Blends, Technology, 13 (2010) 3, pp. 183-188
- Kul, B. S., Ciniviz, M., Assessment of Waste Bread Bioethanol-Gasoline Blends in Respect to Combustion Analysis, Engine Performance and Exhaust Emissions of a SI Engine, Fuel, 277 (2020), 118237
- Suslick, K. S., Sonochemistry, Science, 247 (1990), 4949, pp. 1439-1445
- Jamrozik, A., et al., Effect of Diesel-Biodiesel-Ethanol Blend on Combustion, Performance, and Emissions Characteristics on a Direct Injection Diesel Engine, Thermal Science, 21 (2017), 1B, pp. 591-604
- Nibin, M., et al., Experimental Studies to Improve the Performance, Emission and Combustion Characteristics of Wheat Germ Oil Fuelled CI Engine Using Bioethanol Injection in PCCI Mode, Fuel, 285 (2021), 119196
- Ozer, S., et al., Effects of Liquefed Petroleum Gas Use in a Turbocharged Stratified Injection Engine Using Ethanol/Gasoline as Pilot Fuel, Thermal Science, 25 (2021), Special Issue 1, pp. 189-99
- Abdel-Rahman, A. A., Osman, M. M., Experimental Investigation on Varying the Compression Ratio of SI Engine Working Under Different Ethanol-Gasoline Fuel Blends, International Journal of Energy Research, 21 (1997), 1, pp. 31-40
- Ameri, M., et al., Technical Comparison of a CHP Using Various Blends of Gasohol in an IC Engine, Renewable Energy, 33 (2008), 7, pp. 1469-1474
- ***, Apace Research Ltd, Intensive Field Trial of Ethanol/Petrol Blend in Vehicles, 1998, ERDC Project No. 2511
- Yang, W., et al., Experimental Study of the Bioethanol Substitution Rate and the Diesel Injection Strategies on Combustion and Emission Characteristics of Dual-Fuel-Direct-Injection (DFDI) Engine, Journal of the Energy Institute, 106 (2023), 101153
- Zhang, J., Meguid, S. A., Piezoelectricity of 2D Nanomaterials: Characterization, Properties, and Applications, Semiconductor Science and Technology, 32 (2017), 4, 043006
- Tressler, J. F., et al., Piezoelectric Sensors and Sensor Materials, Journal of Electroceramics, 2, (1998), Dec., pp. 257-272
- Avvaru, B., et al., Ultrasonic Atomization: Effect of Liquid Phase Properties, Ultrasonics, 44 (2006), 2, pp. 146-158
- Suslick, K. S., Nyborg, W. L., Ultrasound: Its Chemical, Physical and Biological Effects, Science, 243 (1989), 4897, 1499
- Ramisetty, K. A., et al., Investigations Into Ultrasound Induced Atomization, Ultrasonics sonochemistry, 20 (2013), 1, pp. 254-264
- Šarković, D., Babović, V., Construction and Functioning of an Efficient Ultrasonic Atomizer, Kragujevac Journal of Sciences (2002), 24, pp. 41-55
- Eknadiosyants, O. K. Role of Cavitation in the Process of Liquid Atomization in an Ultrasonic Fountain, Sov, Phys. Acoust, 14 (1968), 1, pp. 80-84
- Rayleigh W. J. S., The Theory of Sound. Vol. 2, Dover Publications, Mineola, N. Y., USA, 1945, p. 344
- Kudo, T., et al., Effect of Ultrasonic Frequency on Size Distributions of Nanosized Mist Generated by Ultrasonic Atomization, Ultrasonics Sonochemistry, 37 (2017), July, pp. 16-22
- Fırat, M., et al., Experimental Investigation on Combustion and Emission Characteristics of Reactivity Controlled Compression Ignition Engine Powered with Iso-Propanol/Biodiesel Blends, Propulsion and Power Research, 11 (2022), 2, pp. 224-239
- Fırat, M., et al., Comparison of Ethanol/Diesel Fuel Dual Direct Injection (DI2) Strategy with Reactivity Controlled Compression Ignition (RCCI) in a Diesel Research Engine, Energy, 255 (2022), 124556
- Altun, S., et al., Comparison of Direct and Port Injection of Methanol in a RCCI Engine Using Diesel and Biodiesel as High Reactivity Fuels, Process Safety and Environmental Protection, 174 (2023), June, pp. 681-693
- Altun, S., et al., A Study of Oxygen-Enriched Reactivity-Controlled Compression Ignition Combustion in a Diesel Research Engine Under Varying Loadings and Premixed Ratios, Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, doi.org/10.1080/15567036.2021.2020380, 2021
- Cars, U. P., Use of Mıd-Range Ethanol/Gasolıne Blends in Unmodıfıed Passenger Cars and Lıght Duty Trucks, Report, Minnesota Center for Automotive Research, Minnesota State University, Mankato, Minn., USA, 1999
- Turner, D., et al., Combustion Performance of Bio-Ethanol at Various Blend Ratios in a Gasoline Direct Injection Engine, Fuel, 90 (2011), 5, pp. 1999-2006