THERMAL SCIENCE
International Scientific Journal
NUMERICAL INVESTIGATION OF MOLTEN SALT-BASED NANOFLUID LAMINAR HEAT TRANSFER IN A CIRCULAR TUBE USING EULERIAN-LAGRANGIAN METHOD
ABSTRACT
Molten salt-based nanofluid in a laminar region of a circular tube with constant wall heat flux was numerically investigated. An Eulerian-Lagrangian method, discrete phase model, was used to predict the heat transfer performance of nanofluid, considering the factors of inlet Reynolds number, the mass concentration of the nanoparticles, and nanoparticles diameter. Validation results were found in a good match with experimental results obtained from the literature. Numerical results showed that the heat transfer performance of nanofluid was considerably better than that of pure molten salt. The local heat transfer coefficient and Nusselt number of nanofluid are about 30% higher than these of pure molten salt and increase with an increase of Reynolds number and nanoparticles concentration. Moreover, the heat transfer performance of nanofluid with the small size of the nanoparticles (10~100 nm) is improved significantly.
KEYWORDS
PAPER SUBMITTED: 2019-11-01
PAPER REVISED: 2020-06-25
PAPER ACCEPTED: 2020-06-29
PUBLISHED ONLINE: 2020-07-11
THERMAL SCIENCE YEAR
2021, VOLUME
25, ISSUE
Issue 5, PAGES [3427 - 3439]
- Vignarooban, K., et al., Heat transfer fluids for concentrating solar power systems - a review, Applied Energy, 146 (2015), pp. 383-396
- Xiao, P., et al., Investigations on heat transfer characteristic of molten salt flow in helical annular duct, Applied Thermal Engineering, 88 (2015), pp. 22-32
- Wu, Y.T., et al., Experimental study on the heat transfer characteristics of a low melting point salt in a parabolic trough solar collector system, Applied Thermal Engineering, 89 (2015), pp. 748-754
- Holman, J.P., Heat Transfer, John Wiley and Sons Inc., New York, USA, ninth ed., 2002
- Kunugi, T., et al., Direct numerical simulation of turbulent free-surface high Prandtl number fluid flows in fusion reactors, Nuclear Instruments and Methods in Physics Research, 464 (2001), 1, pp. 165-171
- Choi, S.U.S., Eastman, J.A., Enhancing thermal conductivity of fluids with nanoparticles, ASME-Publications-Fed, 231 (1995), 1, pp. 99-106
- Bahiraei, M., Heshmatian, S., Graphene family nanofluids: A critical review and future research directions, Energy Conversion and Management, 196 (2019), pp. 1222-1256
- Bahiraei, M., Particle migration in nanofluids: A critical review, International Journal of Thermal Sciences, 109 (2016), pp. 90-113
- Bahiraei, M., et al., Recent research contributions concerning use of nanofluids in heat exchangers: A critical review, Applied Thermal Engineering, 133 (2018), pp. 137-159
- Bahiraei, M., Heshmatian, S., Electronics cooling with nanofluids: A critical review, Energy Conversion and Management, 172 (2018), pp. 438-456
- Sokhansefat, T., et al., Heat transfer enhancement in parabolic trough collector tube using Al2O3/synthetic oil nanofluid, Renewable and Sustainable Energy Reviews, 33 (2014), pp. 636-644
- Menbari, A., et al., Heat transfer analysis and the effect of CuO/Water nanofluid on direct absorption concentrating solar collector, Applied Thermal Engineering, 104 (2016) pp. 176-183
- Ghaderian, J., et al., Performance of copper oxide/distilled water nanofluid in evacuated tube solar collector (ETSC) water heater with internal coil under thermosyphon system circulations, Applied Thermal Engineering, 121 (2017) pp. 520-536
- Zhang, Z., et al., Enhanced thermal properties of Li2CO3-Na2CO3-K2CO3 nanofluids with nanoalumina for heat transfer in high-temperature CSP systems, Journal of Thermal Analysis and Calorimetry, 128 (2016), 3, pp. 1-10
- Hu, Y., et al., Effect of Al2O3 nanoparticle dispersion on the specific heat capacity of a eutectic binary nitrate salt for solar power applications, Energy Conversion and Management, 142 (2017) pp. 366-373
- Hu, Y., et al., Forced convective heat transfer characteristics of solar salt-based SiO2 nanofluids in solar energy applications, Applied Thermal Engineering, 155 (2019) pp. 650-659
- Ho, M.X., Pan, C., Optimal concentration of alumina nanoparticles in molten hitec salt to maximize its specific heat capacity, International Journal of Heat and Mass Transfer, 70 (2014), pp. 174-184
- Ho, M.X., Pan, C., Experimental investigation of heat transfer performance of molten HITEC salt flow with alumina nanoparticles, International Journal of Heat and Mass Transfer, 107 (2016), pp. 1094-1103
- Bahiraei, M., A numerical study of heat transfer characteristics of CuO-water nanofluid by Euler-Lagrange approach, Journal of Thermal Analysis and Calorimetry, 123 (2016), 2, pp. 1591-1599
- Mahdavi, M., et al., CFD modelling of heat transfer and pressure drops for nanofluids through vertical tubes in laminar flow by Lagrangian and Eulerian approaches, International Journal of Heat and Mass Transfer, 88 (2015), pp. 803-813
- Fard, M. H., et al., Numerical study of convective heat transfer of nanofluids in a circular tube two-phase model versus single-phase model, International Communications in Heat and Mass Transfer, 37 (2010), 1, pp. 91-97
- Boerema, N., et al., Liquid sodium versus Hitec as a heat transfer fluid in solar thermal central receiver systems, Solar Energy 86 (9) (2012) pp. 2293-2305
- Das, S.K., et al., Nanofluids Science and Technology, John Wiley and Sons, Hoboken, USA, 2008
- Manual. FLUENT18.0 User. Fluent Incorporated, 2017.
- Minkowycz, W.J., et al., Handbook of Numerical Heat Transfer, second ed., John Wiley and Sons, Hoboken, USA, 2006, pp. 71.
- Ying, Z., et al., Comparisons of single-phase and two-phase models for numerical predictions of Al2O3/water nanofluids convective heat transfer, Advanced Powder Technology, 31 (2020), 7, pp. 3050-3061
- Kumar, N., Puranik, B.P., Numerical study of convective heat transfer with nanofluids in turbulent flow using a Lagrangian-Eulerian approach, Applied Thermal Engineering, 111 (2017), pp. 1674-1681
- Shah, R.K., London A.L., Laminar Flow Forced Convection in Ducts, Academic Press, New York, USA, 1978, pp. 124-129