ABSTRACT
In order to solve the problem that the auxiliary equipment of electric gas turbine can operate only by relying on external power, and realize the purpose that auxiliary equipment of electric gas turbine can operate independently without the external power grid, in this research, a management system of air source self-powered electric gas generator is proposed. Firstly, the process of the thermal energy management system of the air source self-powered electric gas generator is introduced, and the thermodynamic theory of the thermal energy management system of the air source self-powered electric gas generator is analyzed. Then, the experimental conditions of air source self-powered electric gas generator are introduced. Finally, the results of variable speed and terminal variable flow in heating condition and terminal variable flow in cooling condition of the thermal energy management system of air source self-powered electric gas generator are analyzed. The results show that whether the thermal energy management system of air source self-powered electric gas generator studied in this research is in heating or cooling conditions, both the output power of the engine and the power of the compressor increase with the increase of the rotating speed. It can be concluded from the variable flow results in heating conditions that the smaller the end flow is, the smaller the output power of the engine will be. In this way, the loss of heat transfer efficiency of the plate can be reduced as much as possible, and the users’ demand for heat can be met.
KEYWORDS
PAPER SUBMITTED: 2019-12-23
PAPER REVISED: 2020-01-26
PAPER ACCEPTED: 2020-01-07
PUBLISHED ONLINE: 2020-03-28
THERMAL SCIENCE YEAR
2020, VOLUME
24, ISSUE
Issue 5, PAGES [3395 - 3403]
- Li, G., et al., Experimental study of thermal loading management strategy for the transient process of a rotating turbine disk, Experimental Thermal and Fluid Science, 103 (2019), pp. 234-246.
- Zhang, X., et al., Energy, exergy and economic analysis of biomass and geothermal energy based CCHP system integrated with compressed air energy storage (CAES), Energy Conversion and Management, 199 (2019), pp. 111953.
- Cai, B., et al., Theoretical and experimental study of combined heat and power (CHP) system integrated with ground source heat pump (GSHP), Applied Thermal Engineering, 127 (2017), pp. 16-27.
- Shaofei Wu. Construction of visual 3-d fabric reinforced composite thermal performance prediction system, Thermal Science, 23(2019), 5, pp.2857-2865.
- An, L., et al., Theoretical and experimental study on the lifting performance of bubble pump with variable cross-section lift tube, Applied Thermal Engineering, 111 (2017), pp. 1265-1271.
- Liu, R., et al., Experimental study on thermal balance of regulated two-stage turbocharged diesel engine at variable altitudes, Journal of Thermal Science, 28 (2019), 4, pp. 682-694.
- Kim, I. G., Bang, I. C., Spent nuclear fuel with a hybrid heat pipe for electricity generation and thermal management, Energy conversion and management, 173 (2018), pp. 233-243.
- Du, X., et al., A theoretical and experimental study of typical heterogeneous ice nucleation process on auto windshield under nocturnal radiative cooling and subfreezing conditions, International Journal of Heat and Mass Transfer, 136 (2019), pp. 610-626.
- Chen, T., Cai, L., Energy-Saving Analysis of a Hybrid-Power Gas Engine Heat Pump with Continuously Variable Transmission, International Energy Journal, 18 (2018), 4, pp. 409-418.
- Wang, X., et al., Dynamic analysis of the dual-loop Organic Rankine Cycle for waste heat recovery of a natural gas engine, Energy Conversion and Management, 148 (2017), pp. 724-736.
- Shaofei Wu, Mingqing Wang, Yuntao Zou. Bidirectional cognitive computing method supported by cloud technology, Cognitive Systems Research, 52(2018), pp. 615-621