ABSTRACT
The present study is focused on numerical investigation of heat enhancement and fluid-flow from a heated surface by using nanofluids with three impinging jets. Effects of different volume ratio, different heat flux and different types of nanofluids (CuO-water, Al2O3-water, Cu-water, TiO-water, and pure water) on heat transfer and fluid-flow were studied numerically. The CuO-water nanofluid was used as a coolant in the other parameter. Three impinging jets were used to cool the surface. Low Reynolds number k-ε turbulent model of PHONEICS CFD code was used for numerical analysis. It is obtained that increasing volume ratio from φ=2% to 8% causes an increase of 10.4% on average Nusselt number. Increasing heat flux six times has not a significant effect on average Nusselt number. Using Cu-water nanofluid causes an increase of 2.2%, 5.1%, 4.6%, and 9.6% on average Nusselt number with respect to CuO-water, TiO-water, Al2O3-water, and pure water.
KEYWORDS
PAPER SUBMITTED: 2017-12-04
PAPER REVISED: 2018-02-05
PAPER ACCEPTED: 2018-02-20
PUBLISHED ONLINE: 2018-03-04
THERMAL SCIENCE YEAR
2019, VOLUME
23, ISSUE
Issue 5, PAGES [3165 - 3173]
- Kilic, M., Calisir, T., Baskaya, S., Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging Jet, Journal of the Brazilian Society of Mechanical Sciences and Engineering, 39 (2017), 1, pp. 329-344.
- Kilic, M., Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging Jet, PhD Thesis, Gazi University, Turkey, 2013.
- Manca, O., Ricci, D., Nardini, S., Lorenzo, G., Thermal and fluid dynamics behaviours of confined laminar impinging slot jets with nanofluids, International Communications in Heat and Mass Transfer 70 (2016), pp. 15-26.
- Lin, Z. H., Chou, Y.J., Hung, Y.H., Heat transfer behaviours of a confined slot jet impingement, International Journal of Heat and Mass Transfer, 49 (1999), pp. 2760-2780.
- McGuinn, A., Persoons, T., O'Donovan, T., Murray, D., Surface Heat Transfer from an Impinging Synthetic Air Jet, International Journal of Heat and Mass Transfer, 20 (2005), pp. 1333-1338.
- Teamah, M. A., Dawood, M.M., Shehata, A., Numerical and experimental investigation of flow structure and behavior of nanofluids flow impingement on horizontal flat plate, Experimental Thermal and Fluid Science, 74 (2016), pp. 235-246.
- Sun, B., Qu, Y., Yang, D., Heat transfer of Single Impinging jet with Cu nanofluids, Applied Thermal Engineering, 102 (2016), pp.701-707.
- Umar, A., Naveed, S., Ramzan, N., Experimental Study of laminar forced convection heat transfer of deionized water based copper (I) oxide nanaofluids in tube with constant wall heat flux, Heat Mass Transfer, 52 (2015), pp. 2015-2025.
- Naphon, P., Asssdamongkol, P., Borirak, T., Experimental investigation of titanium nanofluids on the heat pipe thermal efficiency, International Communication Heat and Mass Transfer, 35 (2008), pp.1316-1319.
- Kilic, M.,Ozcan. O., 2017, Numerical Investigation of Heat Transfer and Fluid Flow of Nanofluids with Impinging Jets, Proceedings, International Conference On Advances And Innovations in Engineering, Elazıg, Turkey, 2017, Vol.1, pp.434-440.
- Li, Q., Xuan, Y., Yu, F., , Experimental Investigation of Submerged Single Jet Impingement Using Cu-Water Nanofluid, Applied Thermal Engineering, 36 (2012), 1, pp. 426-433.
- Xuan, Y., Li, Q., Investigation on convective heat transfer and flow features of nanofluids, Trans. ASME J. Heat Transfer, 125 (2003), pp.151-155.52.
- Corcione, M., Empirical correlating quations for predicting the effective thermal conductivity and dynamic viscosity of nanofluids, Energy Conversation Management, 52 (2011), 1, pp.789-93.