THERMAL SCIENCE

International Scientific Journal

Thermal Science - Online First

online first only

Research on key technology and application of flexibility transformation of heating unit to improve clean energy consumption capacity

ABSTRACT
The electric regulation capacity of heating units has been constantly improving due to the promotion of the heating units' flexibility transformation. This improvement has effectively alleviated the long remained serious wind and light abandonment phenomena in the heating season in China. In this paper, we discussed the key technologies of the LP zero output heating mode and bypass heating mode, both of which are widely used in thermo-electric decoupling. Moreover, the coupling transformation of the two heating modes has been successfully realized in a heating unit. The electric regulation capacity of the unit has been greatly improved, from 18.6% before the transformation to 66.7%, and the minimum technical output has been also reduced to 14.2% THA. After the transformation, the unit now is able to provide several heating modes with its operational flexibility greatly improved. By comparing the economical efficiency of these heating modes, we obtained the operation mode with the lowest heat rate. This transformation mode provides a huge grid space for the consumption of clean energy, so it is of positive reference value and exemplary significance in implementing the flexibility transformation of heating units.
KEYWORDS
PAPER SUBMITTED: 2020-06-03
PAPER REVISED: 2020-08-26
PAPER ACCEPTED: 2020-09-22
PUBLISHED ONLINE: 2020-10-31
DOI REFERENCE: https://doi.org/10.2298/TSCI200603309Z
REFERENCES
  1. Meibom, P., et al., Value of Electric Heat Boilers and Heat Pumps for Wind Power Integration, Wind Energy, 10 (2007), 4, pp. 321-337
  2. Ummels, B. C., et al., Integration of large-scale wind power and the use of energy storage in the Netherlands, Iet Renewable Power Generation, 2 (2008), 1, pp. 34-46
  3. Chen, X., et al., Increasing the Flexibility of Combined Heat and Power for Wind Power Integration in China: Modeling and Implications, IEEE Transactions on Power Systems, 30 (2015), 4, pp. 1848-1857
  4. Yu, Y., et al., Comparative Study of Electric Energy Storages and Thermal Energy Auxiliaries for Improving Wind Power Integration in the Cogeneration System, Energy, 11 (2018), 2, pp. 263-279
  5. Lin, F., et al., Optimal operation of a CHP plant for space heating as a peak load regulating plant, Energy, 25 (2000), 4, pp. 283-298
  6. Huang, D. W., et al., Peak-load Regulation Strategy of Power Grid with Cogeneration Units, Proceedings of the CSU-EPSA, 26 (2014), 3, pp. 35-39
  7. Guo, J. S., et al., The Computational Model of the Peak Regulation Capacity of Cogeneration Units and Its Application, E3S Web of Conferences, Guilin China, 2018
  8. Atanasoae, P., et al., Integration of thermal energy storage systems for improved efficiency and flexibility of the combined heat and power plants of medium and small power, International Conference on Electromechanical & Power Systems, Iasi, Romania, 2017
  9. Garoarsdottir, S. O., et al., Improving the flexibility of coal-fired power generators: Impact on the composition of a cost-optimal electricity system, Applied Energy, 209 (2018), 1, pp. 277-289
  10. Scholz, D., et al., Increasing flexibility of combined heat and power plants with Power-to-Heat, 12th International Conference on the European Energy Market (EEM), Lisbon, Portugal, 2015
  11. Kubik, M. L, et al., Increasing thermal plant flexibility in a high renewables power system, Applied Energy, 154 (2015), 15, pp. 102-111
  12. Ju, W. P., et al., Comparison of thermo-electric decoupling techniques for heating units, Thermal Power Generation, 47 (2018), 9, pp. 115-121
  13. Li, J. L., et al., Research on Key Technologies of Electric Boiler with Thermal Energy Storage in Facilitating Wind Power Accommodation Capability, Electrical & Energy Management Technology, (2018), 1, pp. 1-7
  14. Lsmal, K., et al., Models of liquid storage tanks, Energy, 22 (1997), 8, pp.805-815
  15. Binner, M, et al., Flow Patterns in High Pressure Steam Turbines During Low-Load Operation, Journal of Turbomachinery, 136 (2013), 6, pp. 1-12
  16. Ma, Y. L, et al. Dynamic Stress Analysis on LP last-stage Blades of Steam Turbine for Thermal Electrolysis Decoupling, Turbine Technology, 60 (2018), 5, pp. 343-356