International Scientific Journal

Thermal Science - Online First

External Links

online first only

Simulation on cutting forces and cutting temperature in broaching of 300M steel

In this paper, using the method of single factor experiment, set the test parameters of 300 M steel through AdvantEdge software broaching process simulation test, simulation results for the finishing, analyzed the influence of broach rake Angle and relief Angle, tooth lift and cutting speed on cutting force and cutting temperature in the process of broaching, observed the cutting temperature in the broaching process of regional changes, through the analysis, provides theory basis for reasonable design of the broach. The results show that the tooth lift has the greatest influence on the cutting speed, and the tooth lift and cutting speed have the greatest influence on the cutting temperature.
PAPER REVISED: 2019-01-20
PAPER ACCEPTED: 2019-01-30
  1. ZhangH. P., WangC. X.,Du X., et al., Aircraft Landing Gear with Development of 300M Ultra High Strength Ste and Research, journal of Harbin university of science and technology, vol. 16 (2011), pp.73-76.
  2. ZhaoB., XuG. X., HeF., et al.,Present Status and Prospect of Ultra High Strength Steel Applied to Aircraft Landing Gear, jourmal of aeronautical materials, Vol. 37 (2017), pp.1-6.
  3. YanX.,Tao H., GaoX. B., et al., Study on Modeling of Cutting Force For 300M Ultra-High-Strength Steel In High-speed Milling Process, journal of Mechanical Strength, Vol. 30 (2008),pp.860-863.
  4. Zhang H. P., ZhangQ. Y., ZhangX. L., et al.,Study on Cutting Force and Surface Roughness in High speed Milling of 300M Ultra-high-strength Steel, Tool Engineering,Vol. 51 (2017), pp.12-15.
  5. Zhang H. P., ZhangX. L., ZhangH. X.,etal.,Surface Quality of High-speed Turning 300M Ultrahigh Strength Steel, Surface Technology,Vol. 2 (2016), pp.181-187.
  6. Zhang H.P.,ZhangQ. Y., RenY., et al., Simulation and Experiments on Cutting Forces and Cutting Temperature in High Speed Milling of 300M Steel under CMQL and Dry Conditions,International Journal of Precision Engineering &Manufacturing.Vol. 19 (2018),pp.1245-1251.
  7. Sima Z. W., ZhengG. M.,Fang Y. F., Surface Roughness and Residual Stress in High-speed Dry Turning of 300M steel, Modular Machine tool &Automatic Manufacturing Technique, Vol. 12 (2017),pp.121-124.
  8. Zhang H. P., LiuR. H., LiZ. C., et al.,Finite Element Simulation of High Speed Cutting Processing of 300M Ultra-high Strength Steel, Mechanical Science and Technology for Aerospace Engineering,Vol. 36 (2017),pp.1550-1555.
  9. Xing W.Q., Identification of Cutting Simulation Parameters of 300M Steel and Research on Its Surface Quality in Turing
  10. Huang Q., Yin N.D., Research on cutting process of round hole broach based on AdvantEdge, journal of Hubei polytechnic university,Vol. 6(2013), pp.9-11