THERMAL SCIENCE

International Scientific Journal

Thermal Science - Online First

Authors of this Paper

External Links

online first only

Research on fluid heat transfer characteristics of heat pipe radiator directly driven by heat pump

ABSTRACT
The heat pipe radiator directly driven by heat pump heating system has the advantages of fast heat transfer and high energy efficiency. Based on the empirical heat transfer formula, the heat and mass transfer process in the heat pipe radiator was studied. The key parameters in the empirical heat transfer formula were derived by combining with the experimental data. The distribution of the thickness of the condensate film and the heat transfer coefficient in the height direction of the heat pipe radiator was analysed. The influence of the working fluid condensate mass and vapour mass in the heat pipe radiator was investigated. The results showed that the thickness of the liquid film changes from the bottom of 0.1110 mm to the top of 0.0594mm along the height of the heat pipe. The minimum charge of working fluid is 1.78 kg to 1.81 kg and the heating COP of the system still reach to 3.14 even at the outdoor temperature of -12.6 ℃.
KEYWORDS
PAPER SUBMITTED: 2023-11-07
PAPER REVISED: 2023-12-28
PAPER ACCEPTED: 2024-01-04
PUBLISHED ONLINE: 2024-04-14
DOI REFERENCE: https://doi.org/10.2298/TSCI231107081N
REFERENCES
  1. Darmansyah, D., et al., Advancements of Coal Fly Ash and its Prospective Implications for Sustainable Materials in Southeast Asian Countries: A Review
  2. Ministry of Environmental Protection, National Development and Reform Commission, Ministry of Industry and Information Technology, Ministry of Finance, National Energy Administration. Implementation Rules for the Implementation of the Air Pollution Prevention and Control Action Plan in Beijing, Tianjin and Hebei and the surrounding areas, 104(2013).
  3. European Commission. 2009 Directive 2009/28/EC on the Promotion of the Use of Energy From Renewable Sources
  4. Ni, B., et al., Study on Heat Transfer Performance of Pulsating Heat Pipe Heat Exchanger. Nonferrous Metallurgical Equipment, 37(2023), 4, PP, 41-47.
  5. Chotivisarut, N., et al., Seasonal Cooling Load Reduction of Building by Thermosyphon Heat Pipe Radiator in Different Climate Areas. Renewable energy, 38(2012), 1, PP, 188-194.
  6. Zhang, X.X., et al., Dynamic Performance of a Novel Solar Photovoltaic /Loop Heat Pipe Heat Pump System
  7. Sebarchievici, C., et al., Performance Assessment of a Ground-coupled Heat Pump for an Office Room Heating Using Radiator or Radiant Floor Heating Systems. Procedia Engineering, 118(2015), PP, 88-100.
  8. Zhao, W., Zhang. Y.F., Experimental Research on Performance of Low-temperature Thermosyphon Radiant Floor Heating. Gas & heat, 31 (2021), 7, PP, 26-30.
  9. Jiang, A.H., Fu, J.P., Application of the Low-temperature Heat Pipe Panel Radiator. Building Energy & Environment, (2002), 5, PP, 63-64.
  10. Peng, W.J., et al., Experimental and Simulation Study on Thermal Comfort of Direct Expansion Heat Pump Heating System with Different Heat Dissipation Terminals. Science Technology and Engineering, 20(2020), 14, PP, 5764 -5771.
  11. Hirose, M., et al., Development of the General Correlation for Condensation Heat Transfer and Pressure Drop Inside Horizontal 4 mm Small-diameter Smooth and Micro-fin Tubes. International Journal of Refrigeration, 90(2018), PP, 238-248
  12. Rajkumar, M.R., et al., Experimental Study of Condensation Heat Transfer on Hydrophobic Vertical Tube. International Journal of Heat and Mass Transfer, 120(2018), PP, 305-315.
  13. Kim, K., et al., Dropwise Condensation Induced on Chromium Ion Implanted Aluminum Surface. Nuclear Engineering and Technology, 51(2019), 1, PP, 84-94.
  14. Lim, H., et al., Energy Saving Potentials from the Application of Heat Pipes on Geothermal Heat Pump System. Applied Thermal Engineering, 126(2017), PP, 1191-1198.
  15. Ma, Y.X., et al., Experimental Study on Heat Transfer Performance of Finned Gravity Heat Pipe. CIESC Journal, 71(2020), 2, PP, 594-601.
  16. Jiao, B., et al., Investigation on the Effect of Filling Ratio on the Steady-state Heat Transfer Performance of a Vertical Two-phase Closed Thermosyphon. Applied Thermal Engineering, 28(2008), PP, 1417-1426.
  17. Tsai, T.E., et al., Dynamic Test Method for Determining the Thermal Performances of Heat Pipes. International Journal of Heat and Mass Transfer, 53(2010), 21, PP, 4567-4578.
  18. Zhan, H.R., et al., Simulation Study on Flow and Heat-transfer Characteristics of Gravity Heat Pipes. Journal of Chinese Society of Power Engineering, 37(2017), 7, PP, 540-545.
  19. Solanki, A. K., Kumar, R., Condensation Heat Transfer and Pressure Drop Characteristics of R-134a Inside the Flattened Tubes at High Mass Flux and Different Saturation Temperature. Experimental Heat Transfer, 32(2019), 7, PP, 69-84(16).
  20. Qian, J.J., et al. Study on Natural Convection Heat Transfer Characteristics of Composite Substrate /Heat Pipe Fin Heat Sink
  21. Shi, F.Z., Gan. Y.H., Numerical Simulation of Start-up Characteristics and Heat Transfer Performance of Ultra-thin Heat Pipe
  22. Jin, L.Q., et al., Study on the Influence Parameters of Two-phase Heat Transfer Characteristics of Gravity Heat Pipe
  23. Xu, S.X., et al., Investigation of Air-source Heat Pump Using Heat Pipes as Heat Radiator. International Journal of Refrigeration, 90(2018), PP, 91-98.
  24. Xu, S.X., et al., Air Source Heat Pump /Heat Pipe Domestic Room Heating System: Design and Experimental Research. Applied Thermal Engineering, 192(2021), PP, 116930.
  25. Wang, B.X., Engineering Heat and Mass Transfer (Second Volume), Beijing: Science Press, (2020), PP, 451-452.
  26. Moffat, R.J. Using Uncertainty Analysis in the Planning of an Experiment. Journal of Fluids Engineering, 107(1985), 2, PP, 173-178.
  27. Zhan, B.R., et al., Simulation Study on Flow and Heat-transfer Characteristics of Gravity Heat Pipes. Journal of Chinese Society of Power Engineering,37(2017),7, PP, 540-545.
  28. Jiao, B., et al., Investigation on the effect of filling ratio on the steady-state heat transfer performance of a vertical two-phase closed thermosyphon. Applied Thermal Engineering, 28 (2008), 1417-1426.