TY - JOUR TI - Numerical studies of spray breakup in a gasoline direct injection (GDI) engine AU - Jafarmadar Samad AU - Heidarpoor Vahied JN - Thermal Science PY - 2011 VL - 15 IS - 4 SP - 1111 EP - 1122 PT - Article AB - The objective of this study is to investigate Spray Breakup process of sprays injected from single and two-hole nozzles for gasoline direct Injection (GDI) engines by using three dimensional CFD code. Spray characteristics were examined for spray tip penetration and other characteristics including: the vapor phase concentration distribution and droplet spatial distribution, which were acquired using the computational fluid dynamics (CFD) simulation. Results showed that as the hole-axis-angle (γ) of the two-hole nozzle decreased, the droplet coalescence increased and vapor mass decreased. The spray with cone angle (θ0) 5 deg for single hole nozzle has the longest spray tip penetration and the spray with the γ of 30 deg and spray cone angle θ0=30 deg for two hole nozzles had the shortest one. Also, when the spray cone angle (θ0) and hole-axis-angle (γ) increased from 5 to 30 deg, the Sauter mean diameter (SMD) decreased for both single-hole and two-hole nozzles used in this study. For a single-hole nozzle, when spray cone angle increased from 5 to 30 deg, the vaporization rate very much because of low level of coalescence. The result of model for tip penetration is good agreement with the corresponding experimental data in the literatures.