TY - JOUR
TI - Speed and tensile force control of the pulling devices of the continuous line
AU - Nikolić Saša S
AU - Kocić Igor B
AU - Antić Dragan S
AU - Mitić Darko B
AU - Danković Nikola B
AU - Milovanović Miroslav B
AU - Đekić Petar S
JN - Thermal Science
PY - 2023
VL - 27
IS - 6
SP - 4447
EP - 4460
PT - Article
AB - In cable production, it is imperative to control speed and tension. This paper proposes a web tensile force regulation between input and output pulling caterpillar devices. The web tensile force is controlled indirectly using a PI controller based on feedback information about tensile force using a tensile observer. This paper also deals with the regulation speed of the input-pulling caterpillar device and the speed and torque (current) of output pulling caterpillar device and deals with the effect of line speed on the temperature change at the extruder zones. The input and output-pulling caterpillar devices are connected by the web material that is processed on them. The input and output-pulling caterpillar devices are connected by the web material that is processed on them. The task was realized using a programmable logic controller Micrologix 1200 controller and SIMOREG DC drives, which regulate the input caterpillar's speed and output caterpillar's torque. The identification of separately excited DC motors parameters was made. Models for the input, output caterpillars and web zone were simulated in MATLAB and SIMULINK. The controllers of the current loop, velocity loop, and tension loop are all integral isolated PI regulators. Speed signal is obtained by tacho generator. In practical realization, tensile force is observed directly from the Simoreg DC converter, eliminating the tension sensor. The tensile force controller is realized with the PI controller, which was realized with programmable logic controller. Setting optimal parameters is performed using ITAE criteria. The ITAE function is calculated using a complex Simpson's quadrature formula.