THERMAL SCIENCE

International Scientific Journal

Thermal Science - Online First

External Links

online first only

Modeling of nucleate boiling heat transfer of a stagnation-point flow impinging on a hot surface

ABSTRACT
A model using modified superposition approach is developed to predict the rate of heat transfer in the stagnation region of a planar jet impingement boiling on a hot flat surface. The total heat flux in this model is based on the combination of the single phase forced convection and nucleate pool boiling components. The single-phase component is calculated by using similarity solution approach. The applicability of the model is investigated on the boiling curves under conditions of single phase, partial and fully developed nucleate boiling. The Effect of main parameters of water jet, i.e. jet sub-cooling, jet velocity and nozzle to plate distance on the heat flux, is of concerned. A comparison of the obtained results of the model is made with various published experimental data and good agreement is reported.
KEYWORDS
PAPER SUBMITTED: 2017-12-20
PAPER REVISED: 2018-05-24
PAPER ACCEPTED: 2018-05-28
PUBLISHED ONLINE: 2018-06-03
DOI REFERENCE: https://doi.org/10.2298/TSCI171220163M
REFERENCES
  1. Inada, S., Miyasaka, Y., and Izumi, R., 1981, "A Study on the Laminar-flow Heat Transfer Between a Two-dimensional Water Jet and a Flat Surface with Constant Heat Flux," Bulletin of JSME, 24(196), pp. 1803-1810.
  2. Zumbrunnen, D. A., 1991, "Convective Heat and Mass Transfer in the Stagnation Region of a Laminar Planar Jet Impinging on a Moving Surface," Journal of Heat Transfer, 113(3), pp. 563-570.
  3. Zuckerman, N., and Lior, N., 2006, "Jet Impingement Heat Transfer: Physics, Correlations, and Numerical Modeling," Advances in Heat Transfer, 39, pp. 565-631.
  4. Benmouhoub, D., and Mataoui, A., 2014, "Computation of heat transfer of a plane turbulent jet impinging a moving plate," Thermal Science, 18(4), pp. 1259-1271.
  5. Qiu, S., Xu, P., Geng, L., Mujumdar, A. S., Jiang, Z., and Yang, J., 2015, "Enhanced heat transfer characteristics of conjugated air jet impingement on a finned heat sink," Thermal Science(00), pp. 30-30.
  6. Monde, M., 1985, "Critical heat flux in saturated forced convective boiling on a heated disk with an impinging jet," Wärme - und Stoffübertragung, 19(3), pp. 205-209.
  7. Miyasaka, Y., and Inada, S., 1980, "THE EFFECT OF PURE FORCED CONVECTION ON THE BOILING HEAT TRANSFER BETWEEN A TWO-DIMENSIONAL SUBCOOLED WATER JET AND A HEATED SURFACE," Journal of Chemical Engineering of Japan, 13(1), pp. 22-28.
  8. Vader, D., Incropera, F., and Viskanta, R., 1992, "Convective nucleate boiling on a heated surface cooled by an impinging, planar jet of water," Journal of Heat Transfer, 114(1), pp. 152-160.
  9. Wolf, D., Incropera, F., and Viskanta, R., 1993, "Jet impingement boiling," Advances in heat transfer, 23, pp. 1-132.
  10. Robidou, H., Auracher, H., Gardin, P., and Lebouché, M., 2002, "Controlled cooling of a hot plate with a water jet," Experimental Thermal and Fluid Science, 26(2), pp. 123-129.
  11. Hauksson, A. T., 2001, "Experimental study of boiling heat transfer during water jet impingement on a hot steel plate," The University of British Columbia, Canada.
  12. Chen, J. C., 1966, "Correlation for boiling heat transfer to saturated fluids in convective flow," Industrial & engineering chemistry process design and development, 5(3), pp. 322-329.
  13. Summerfield, S. I., 2004, "Boiling heat transfer for an impinging jet on a hot plate and the development of a new correlation," University of Manitoba.
  14. Liu, Z., and Winterton, R., 1991, "A general correlation for saturated and subcooled flow boiling in tubes and annuli, based on a nucleate pool boiling equation," International journal of heat and mass transfer, 34(11), pp. 2759-2766.
  15. Dhir, V. K., 2006, "Mechanistic prediction of nucleate boiling heat transfer-achievable or a hopeless task?," Journal of Heat Transfer, 128(1), pp. 1-12.
  16. Omar, A. M., 2010, "Experimental Study and Modeling of Nucleate Boiling During Free Planar Liquid Jet Impingement," P.hD., McMaster University.
  17. Rohsenow, W., 1952, "Heat transfer with evaporation, heat transfer-A Symposium held at the University of Michigan during the summer of 1952," Univ. of Michigan Press, Ann Arbor.
  18. Bergles, A., and Rohsenow, W., 1964, "The determination of forced-convection surface-boiling heat transfer," Journal of Heat Transfer, 86(3), pp. 365-372.
  19. Rohsenow, W. M., 1951, "A method of correlating heat transfer data for surface boiling of liquids," Cambridge, Mass.: MIT Division of Industrial Cooporation,
  20. .
  21. Mohaghegh, M. R., and Rahimi, A. B., 2016, "Three-Dimensional Stagnation-Point Flow and Heat Transfer of a Dusty Fluid Toward a Stretching Sheet," Journal of Heat Transfer, 138(11), pp. 112001-112001-112012.
  22. Lienhard, J., 1995, "Liquid jet impingement," Annual Review of Heat Transfer, 6(6).
  23. Kleiber, M., Joh, R., and Span, R., 2010, "D3 Properties of Pure Fluid Substances," VDI Heat Atlas, Springer Berlin Heidelberg, Berlin, Heidelberg, pp. 301-418.
  24. Collier, J. G., and Thome, J. R., 1994, Convective boiling and condensation, Clarendon Press, Oxford.
  25. Forster, H., and Zuber, N., 1955, "Dynamics of vapor bubbles and boiling heat transfer," AIChE Journal, 1(4), pp. 531-535.
  26. Stephan, K., and Abdelsalam, M., 1980, "Heat-transfer correlations for natural convection boiling," International Journal of Heat and Mass Transfer, 23(1), pp. 73-87.
  27. Cooper, M., 1984, "Heat flow rates in saturated nucleate pool boiling-a wide-ranging examination using reduced properties," Advances in heat transfer, 16, pp. 157-239.
  28. Gorenflo, D., and Kenning, D., 2010, "H2 Pool Boiling," VDI Heat Atlas, Springer Berlin Heidelberg, Berlin, Heidelberg, pp. 757-792.
  29. Fazel, A., Ali, S., Jamialahmadi, M., and Safekordi, A. A., 2008, "Experimental investigation in pool boiling heat transfer of pure/binary mixtures and heat transfer correlations," Iranian Journal of Chemistry and Chemical Engineering (IJCCE), 27(3), pp. 135-150.
  30. Hsu, Y., 1962, "On the size range of active nucleation cavities on a heating surface," Journal of Heat Transfer, 84(3), pp. 207-213.